Neptune Direct Connect 8

The Direct Connect 8 modules features 8 solid-state controlled outlets each capable of switching 120V at 6 Amps. The DC8 enables a very reliable hardwired connection between the AquaController and all controlled devices - X10 interference problems caused by noisey electronic ballasts (i.e. Blueline) are eliminated.

• 8x120V Outlets (Max 6 Amps, total current must be less than 15 Amps)
• Compact custom aluminum enclosure (8.8" x 3.35" x 1.6")
• High reliability direct wired connection to the AquaController (does not use X10)
• Can be used with electronic ballasts which cause X10 interference
• Completely Silent Operation uses solid state relays
• "Soft-Start" for reduced pump wear
• Up to 4 DC8s can be daisy chained together for up to 32 switched outlets
• Control Interface (IM513) can be last device in chain (Simultaneous X10 and hardwired control)
• Fuse Protected
• 4 Mounting Holes for easy installation

The Direct Connect 8 modules features 8 solid-state controlled outlets each capable of switching 120V at 6 Amps. The DC8 enables a very reliable hardwired connection between the AquaController and all controlled devices - X10 interference problems caused by noisey electronic ballasts (i.e. Blueline) are eliminated. NOTE: This module is suitable for use on ICECAP™ ballasts.   

8 120V Outlets (Max 6 Amps, total current must be less than 15 Amps). 

Compact custom aluminum enclosure (8.8" x 3.35" x 1.6"). 

High reliability direct wired connection to the AquaController (does not use X10). 

Can be used with electronic ballasts which cause X10 interference. 

Completely Silent Operation uses solid state relays. 

"Soft-Start" for reduced pump wear. 

Up to 4 DC8s can be daisy chained together for up to 32 switched outlets. 

Control Interface (IM513) can be last device in chain (Simultaneous X10 and hardwired control)

Fuse Protected 

4 Mounting Holes for easy installation