For Medium Sized Aquariums - 130 to 500 Gallons
Efficient Cooling Technology
Internationally-recognized high-end compressors and titanium coaxial heat exchangers provide high performance, low energy consumption and low noise levels.
Digital Thermostat
Intuitive controller with accurate temperature detection from 32 to 95°F. Closed loop temperature control system with extremely tight differential of 1°F. Displays in °F or °C, and audible alarms for certain situations.
Efficient Design
Solid and durable structure designed to guarantee near perfect protection against corrosion. Rotatable in-set water connections, rotatable exhaust conveyor, and smaller form-factor helps facilitate placement of chiller in confined spaces.
Cooling Performance
Ability of the TANK TK-2000 to pull down water temperatures in an 86°F room:
AQUARIUM SIZE |
TEMP. ATTAINABLE |
HEATING LOAD |
NET PULL-DOWN |
C.O.P.* |
530 gallons |
77°F |
1.89 watts/gal. |
9°F cooler |
2.2 |
105 gallons |
47°F |
0.38 watts/gal. |
39°F cooler |
1.4 |
Heater Kit
The 440w heater kit is designed to work universally with all Teco SeaChill Aquarium Chillers. Installation is easy and takes less than 10 minutes. No tools required. Includes an installation guide.
Optional Air Conveyor Extension Kit (Available as an add-on purchase.)
A kit of two modular extensions designed to extend the opening of the top-side rotating conveyor on TK-500, TK-1000 and TK-2000 aquarium chillers. Chillers can overheat when placed inside a cabinet or confined space, resulting in decreased performance, increased energy utilization, and permanent damage to internal components. These extensions can be used to help channel heat further away from the chiller's operating environment. Extensions can also be mounted to the sides of cabinets using the pre-marked holes as a guide.
Each extension is modular and extends the conveyor's vent in 2 inch increments (up to 4 inches per kit).
Optional Flow Indicator (Available as an add on purchase)
The TECO Flow Indicator is an important accessory for most aquarium system setups. Connect the Flow Indicator to any pipe or tubing that water flows through. The red fan in the middle will spin--a visual indication that water is presently flowing. The Flow Indicator can also be used to "join" tubes or pipes together.
Technical Specifications:
- Horsepower: 1/3HP
- Minimum Flow Rate: 158 gph
- Maximum Flow Rate: 211 gph
- In/Out Water Connection: 3/4" Tube Diameter
- Exchanger: Titanium
- Supply: 115V-60Hz
- Power Consumption: 440 Watt
- Gas/Refrigerant: R134A
- Weight: 47.4 lbs. (21.5kg)
- Dimensions: 12.2"x12.2"x19.69"
Included Inside The Box
Printed Manual
QTY. 1
|
Pipe Joint With Gasket
QTY. 2
|
2" Conveyor Extension
QTY. 1
|
Key for Conveyor Position
QTY. 1
|
Cable Tie
QTY. 2
|
Squeeze-Tube Clamp
QTY. 2
|
Velcro® Bundler
QTY. 2
|
Power Cable
QTY. 1
|